29 CFR 1910 · General Industry

1910.1001(d): Asbestos Exposure Monitoring

By Black Belt Safety Editorial Team Official text as of octubre 15, 2026 Data updated noviembre 6, 2026 6 min read

In plain words:

Employers must determine asbestos exposure from breathing zone samples representing each employee's 8-hour TWA and 30-minute short-term exposures, by shift, job classification and work area. They must do initial monitoring of employees exposed or reasonably expected to be exposed at or above the TWA permissible exposure limit or excursion limit, with exceptions for qualifying earlier monitoring after March 31, 1992, or objective data.

Key takeaways

  • 1910.1001(d) is part of OSHA's general industry standards (29 CFR Part 1910).
  • OSHA cited it 19 times in the last 3 years, in 19 inspections, with $183,263 in current penalties.
  • Most citations: NY (5), PR (2), MI (2).
  • Related part: 1910.1001(d)(2) Initial monitoring (11 citations).
  • Free 5-minute toolbox talk for your crew below.

Get the free 5-minute toolbox talk on 1910.1001(d) ↓

19citations, 3 years
$183,263current penalties
19inspections
0linked injury cases
In this article
  1. What this rule covers
  2. Official text
  3. Where and how often it was cited
  4. Free toolbox talk
  5. OSHA interpretation letters
  6. Related parts of this rule
  7. Get your crew competent
  8. Frequently asked questions
  9. About this page

What this rule covers

29 CFR 1910.1001(d) ("Exposure monitoring") is one requirement inside 1910.1001 Asbestos, an OSHA general industry standard (Part 1910). It includes 21 sub-paragraphs. The official text below is copied word for word from the Electronic Code of Federal Regulations (eCFR). The numbers, injury cases and training on this page show how OSHA enforces it on real job sites.

Official text

(d) Exposure monitoring — 19 citations

(1) General. 3 citations

(i) Determinations of employee exposure shall be made from breathing zone air samples that are representative of the 8-hour TWA and 30-minute short-term exposures of each employee. 3 citations

(ii) Representative 8-hour TWA employee exposures shall be determined on the basis of one or more samples representing full-shift exposures for each shift for each employee in each job classification in each work area. Representative 30-minute short-term employee exposures shall be determined on the basis of one or more samples representing 30 minute exposures associated with operations that are most likely to produce exposures above the excursion limit for each shift for each job classification in each work area.

(2) Initial monitoring. Open (d)(2) 11 citations

(i) Each employer who has a workplace or work operation covered by this standard, except as provided for in paragraphs (d)(2)(ii) and (d)(2)(iii) of this section, shall perform initial monitoring of employees who are, or may reasonably be expected to be exposed to airborne concentrations at or above the TWA permissible exposure limit and/or excursion limit. Open (d)(2)(i) 11 citations

(ii) Where the employer has monitored after March 31, 1992, for the TWA permissible exposure limit and/or the excursion limit, and the monitoring satisfies all other requirements of this section, the employer may rely on such earlier monitoring results to satisfy the requirements of paragraph (d)(2)(i) of this section.

(iii) Where the employer has relied upon objective data that demonstrate that asbestos is not capable of being released in airborne concentrations at or above the TWA permissible exposure limit and/or excursion limit under the expected conditions of processing, use, or handling, then no initial monitoring is required. Open (d)(2)(iii)

(3) Monitoring frequency (periodic monitoring) and patterns. After the initial determinations required by paragraph (d)(2)(i) of this section, samples shall be of such frequency and pattern as to represent with reasonable accuracy the levels of exposure of the employees. In no case shall sampling be at intervals greater than six months for employees whose exposures may reasonably be foreseen to exceed the TWA permissible exposure limit and/or excursion limit.

(4) Changes in monitoring frequency. If either the initial or the periodic monitoring required by paragraphs (d)(2) and (d)(3) of this section statistically indicates that employee exposures are below the TWA permissible exposure limit and/or excursion limit, the employer may discontinue the monitoring for those employees whose exposures are represented by such monitoring.

(5) Additional monitoring. Notwithstanding the provisions of paragraphs (d)(2)(ii) and (d)(4) of this section, the employer shall institute the exposure monitoring required under paragraphs (d)(2)(i) and (d)(3) of this section whenever there has been a change in the production, process, control equipment, personnel or work practices that may result in new or additional exposures above the TWA permissible exposure limit and/or excursion limit or when the employer has any reason to suspect that a change may result in new or additional exposures above the PEL and/or excursion limit.

(6) Method of monitoring.

(i) All samples taken to satisfy the monitoring requirements of paragraph (d) of this section shall be personal samples collected following the procedures specified in appendix A.

(ii) All samples taken to satisfy the monitoring requirements of paragraph (d) of this section shall be evaluated using the OSHA Reference Method (ORM) specified in appendix A of this section, or an equivalent counting method.

(iii) If an equivalent method to the ORM is used, the employer shall ensure that the method meets the following criteria:

(A) Replicate exposure data used to establish equivalency are collected in side-by-side field and laboratory comparisons; and

(B) The comparison indicates that 90% of the samples collected in the range 0.5 to 2.0 times the permissible limit have an accuracy range of plus or minus 25 percent of the ORM results at a 95% confidence level as demonstrated by a statistically valid protocol; and

(C) The equivalent method is documented and the results of the comparison testing are maintained.

(iv) To satisfy the monitoring requirements of paragraph (d) of this section, employers must use the results of monitoring analysis performed by laboratories which have instituted quality assurance programs that include the elements as prescribed in appendix A of this section.

(7) Employee notification of monitoring results. 5 citations

(i) The employer must, within 15 working days after the receipt of the results of any monitoring performed under this sections, notify each affected employee of these results either individually in writing or by posting the results in an appropriate location that is accessible to affected employees. 5 citations

(ii) The written notification required by paragraph (d)(7)(i) of this section shall contain the corrective action being taken by the employer to reduce employee exposure to or below the TWA and/or excursion limit, wherever monitoring results indicated that the TWA and/or excursion limit had been exceeded.

Source: eCFR, text current as of 2026-10-15. Read all of 1910.1001.

See every company cited for this rule.

Export the list: 19 inspections cited 1910.1001(d) in the last 3 years, with employer, location, penalty and date.

Purple Belt, $59/mo

Where and how often it was cited

YearCitations
20249
20253
20267

Top states: NY (5), PR (2), MI (2), NC (2), OR (1)

Largest penalties

EmployerLocationPenalty for this rule
MEDICAL ASSOCIATES CLINIC, P.C.DUBUQUE, IA$148,963
157789 - GENERAL DYNAMICS MISSION SYSTEMS, INC.GREENSBORO, NC$12,000
317735730 - RICK FRANKLIN CORPLEBANON, OR$8,300
69027 - HAIER US APPLIANCE SOLUTIONS INCLOUISVILLE, KY$5,500
DANARANJITO, PR$5,000

Free toolbox talk

A 5-minute crew talk on 1910.1001(d), plus alerts when this rule changes. Free.




OSHA interpretation letters

None exist. OSHA has not published a letter of interpretation for 1910.1001(d).

Related parts of this rule

Get your crew competent

Trainers on Black Belt Safety: Marc Harvey

Trainers and suppliers: feature your business on this rule for $25/month.

Frequently asked questions

What must asbestos samples represent?

The 8-hour TWA and 30-minute short-term exposures of each employee, with samples for each shift, job classification and work area.

Who needs initial monitoring?

Employees who are, or may reasonably be expected to be, exposed at or above the TWA permissible exposure limit and/or excursion limit.

When is initial monitoring not required?

When objective data show asbestos cannot be released at or above the TWA PEL or excursion limit, or when qualifying monitoring was done after March 31, 1992.

About this page

Sources

3-year window. Federal OSHA only; state-plan rules are not counted. Plain-language text is a summary, not legal advice; the official text controls. Black Belt Safety is not part of OSHA or the Department of Labor.

Written and reviewed by

Black Belt Safety Editorial Team

Site Safety Officer and Safety Professional

OSHA 30 · CPR · USACE CQM

Written and reviewed by the Black Belt Safety team. Every post is checked against the OSHA standard or agency source it cites.

Desplácese hacia arriba