1910.180(h)(3): Moving Loads With Crawler, Locomotive and Truck Cranes
Employers must make sure the crane is level and blocked where needed and the load is secured and balanced before lifting more than a few inches. Before hoisting, ropes must not be kinked or twisted and the hook must be over the load. Loads must not be jerked, hit obstructions or be dragged sideways, nobody may ride the load or hook, operators should avoid carrying loads over people, and brakes must be tested on loads approaching rated load.
Key takeaways
- 1910.180(h)(3) is part of OSHA's general industry standards (29 CFR Part 1910, Subpart N).
- OSHA cited it 28 times in the last 3 years, in 25 inspections, with $117,232 in current penalties.
- 2 deaths are linked to inspections that cited this rule.
- Most citations: TX (6), FL (4), IN (3).
- Related part: 1910.180(h) Handling the load (37 citations).
- Free 5-minute toolbox talk for your crew below.
Get the free 5-minute toolbox talk on 1910.180(h)(3) ↓
In this article
What this rule covers
29 CFR 1910.180(h)(3) ("Moving the load") is one requirement inside 1910.180 Crawler locomotive and truck cranes, an OSHA general industry standard (Part 1910, Subpart N). It includes 19 sub-paragraphs. The official text below is copied word for word from the Electronic Code of Federal Regulations (eCFR). The numbers, injury cases and training on this page show how OSHA enforces it on real job sites.
Official text
(3) Moving the load. 28 citations
(i) The employer shall assure that: Open (h)(3)(i) 6 citations
(a) The crane is level and where necessary blocked properly.
(b) The load is well secured and properly balanced in the sling or lifting device before it is lifted more than a few inches.
(ii) Before starting to hoist, the following conditions shall be noted:
(a) Hoist rope shall not be kinked.
(b) Multiple part lines shall not be twisted around each other.
(c) The hook shall be brought over the load in such a manner as to prevent swinging.
(iii) During hoisting care shall be taken that: 4 citations
(a) There is no sudden acceleration or deceleration of the moving load.
(b) The load does not contact any obstructions.
(iv) Side loading of booms shall be limited to freely suspended loads. Cranes shall not be used for dragging loads sideways. 1 citations
(v) No hoisting, lowering, swinging, or traveling shall be done while anyone is on the load or hook. Open (h)(3)(v) 12 citations
(vi) The operator should avoid carrying loads over people. 1 citations
(vii) On truck-mounted cranes, no loads shall be lifted over the front area except as approved by the crane manufacturer.
(viii) The operator shall test the brakes each time a load approaching the rated load is handled by raising it a few inches and applying the brakes.
(ix) Outriggers shall be used when the load to be handled at that particular radius exceeds the rated load without outriggers as given by the manufacturer for that crane. Where floats are used they shall be securely attached to the outriggers. Wood blocks used to support outriggers shall: Open (h)(3)(ix) 3 citations
(a) Be strong enough to prevent crushing.
(b) Be free from defects.
(c) Be of sufficient width and length to prevent shifting or toppling under load.
(x) Neither the load nor the boom shall be lowered below the point where less than two full wraps of rope remain on their respective drums.
(xi) Before lifting loads with locomotive cranes without using outriggers, means shall be applied to prevent the load from being carried by the truck springs.
(xii) When two or more cranes are used to lift one load, one designated person shall be responsible for the operation. He shall be required to analyze the operation and instruct all personnel involved in the proper positioning, rigging of the load, and the movements to be made.
(xiii) In transit the following additional precautions shall be exercised:
(a) The boom shall be carried in line with the direction of motion.
(b) The superstructure shall be secured against rotation, except when negotiating turns when there is an operator in the cab or the boom is supported on a dolly.
(c) The empty hook shall be lashed or otherwise restrained so that it cannot swing freely.
(xiv) Before traveling a crane with load, a designated person shall be responsible for determining and controlling safety. Decisions such as position of load, boom location, ground support, travel route, and speed of movement shall be in accord with his determinations.
(xv) A crane with or without load shall not be traveled with the boom so high that it may bounce back over the cab.
(xvi) When rotating the crane, sudden starts and stops shall be avoided. Rotational speed shall be such that the load does not swing out beyond the radii at which it can be controlled. A tag or restraint line shall be used when rotation of the load is hazardous. 1 citations
(xvii) When a crane is to be operated at a fixed radius, the boom-hoist pawl or other positive locking device shall be engaged.
(xviii) Ropes shall not be handled on a winch head without the knowledge of the operator.
(xix) While a winch head is being used, the operator shall be within convenient reach of the power unit control lever.
Source: eCFR, text current as of 2026-10-15. Read all of 1910.180.
Export the list: 25 inspections cited 1910.180(h)(3) in the last 3 years, with employer, location, penalty and date.
Purple Belt, $59/moInjuries linked to this rule
2 deaths are linked to inspections where OSHA cited 1910.180(h)(3).
At 3:31 p.m. on January 2, 2025, an employee was operating a spider lift on sitewhile cutting a tree. During the work, the tree crane collapsed and struck the spider lift. The employee fell to the ground and sustained multiple injuries. The employee was hospitalized…
Full case list with employer, penalty, filters and download is part of OSHA Data (Purple Belt).
Unlock with Purple BeltWhere and how often it was cited
| Year | Citations |
|---|---|
| 2023 | 2 |
| 2024 | 11 |
| 2025 | 8 |
| 2026 | 7 |
Top states: TX (6), FL (4), IN (3), OR (2), MA (2)
Largest penalties
| Employer | Location | Penalty for this rule |
|---|---|---|
| FLYWAY ACCESS, LLC | OCALA, FL | $16,550 |
| GULF MARINE REPAIR CORPORATION | TAMPA, FL | $16,550 |
| LIGHTNING OILFIELD SERVICES, INC. | BIG SPRING, TX | $9,679 |
| GOLDSMITH UNIT SERVICES, LLC | GARDEN CITY, TX | $9,268 |
| A & J TREE AND LANDSCAPING SERVICES LLC | TROY, NY | $8,067 |
Free toolbox talk
A 5-minute crew talk on 1910.180(h)(3), plus alerts when this rule changes. Free.
OSHA interpretation letters
None exist. OSHA has not published a letter of interpretation for 1910.180(h)(3).
Related parts of this rule
- 1910.180(h) Handling the load 37 citations
- 1910.180(h)(3)(v) 12 citations
- 1910.180(h)(3)(i) 6 citations
- 1910.180(h)(3)(ix) 3 citations
- 1910.180(h)(2)(ii)
- 1910.180(h)(2) Attaching the load
Get your crew competent
Trainers on Black Belt Safety: Marc Harvey
Trainers and suppliers: feature your business on this rule for $25/month.
Frequently asked questions
When must the load be secured and balanced?
Before it is lifted more than a few inches.
Can someone ride on the load or hook?
No. No hoisting, lowering, swinging or traveling may be done while anyone is on the load or hook.
When must the brakes be tested?
Each time a load approaching the rated load is handled, by raising it a few inches and applying the brakes.
About this page
Sources
- 29 CFR 1910.180 (eCFR), text current as of 2026-10-15
- U.S. Department of Labor enforcement data: OSHA inspections, citations and accident records, copied nightly; data as of 2026-11-06
3-year window. Federal OSHA only; state-plan rules are not counted. Plain-language text is a summary, not legal advice; the official text controls. Black Belt Safety is not part of OSHA or the Department of Labor.