29 CFR 1910 · General Industry · Subpart R

1910.268(b)(7): Approach Distances to Overhead Power Lines

By Black Belt Safety Editorial Team Official text as of October 15, 2026 Data updated November 17, 2026 3 min read

In plain words:

In telecommunications work, employers must ensure no employee approaches or takes any conductive object closer to energized overhead power lines and parts than Table R-2 allows, unless the employee is insulated or guarded, the energized parts are insulated or guarded, or the lines are deenergized and grounded. Table R-2 distances range from avoiding contact at 300 V and less up to 54 inches for over 121 kV, not over 140 kV.

Key takeaways

  • 1910.268(b)(7) is part of OSHA's general industry standards (29 CFR Part 1910, Subpart R).
  • OSHA cited it 18 times in the last 3 years, in 18 inspections, with $148,368 in current penalties.
  • 4 deaths are linked to inspections that cited this rule.
  • Most citations: OH (4), TX (4), MI (2).
  • Related part: 1910.268(b) General (22 citations).
  • Free 5-minute toolbox talk for your crew below.

Get the free 5-minute toolbox talk on 1910.268(b)(7) ↓

18citations, 3 years
$148,368current penalties
18inspections
4linked deaths
In this article
  1. What this rule covers
  2. Official text
  3. Injuries linked to this rule
  4. Where and how often it was cited
  5. Free toolbox talk
  6. OSHA interpretation letters
  7. Related parts of this rule
  8. Get your crew competent
  9. Frequently asked questions
  10. About this page

What this rule covers

29 CFR 1910.268(b)(7) ("Approach distances to exposed energized overhead power lines and parts") is one requirement inside 1910.268 Telecommunications, an OSHA general industry standard (Part 1910, Subpart R). It includes 3 sub-paragraphs. The official text below is copied word for word from the Electronic Code of Federal Regulations (eCFR). The numbers, injury cases and training on this page show how OSHA enforces it on real job sites.

Official text

(7) Approach distances to exposed energized overhead power lines and parts. The employer shall ensure that no employee approaches or takes any conductive object closer to any electrically energized overhead power lines and parts than prescribed in Table R-2, unless: 18 citations

(i) The employee is insulated or guarded from the energized parts (insulating gloves rated for the voltage involved shall be considered adequate insulation), or

(ii) The energized parts are insulated or guarded from the employee and any other conductive object at a different potential, or

(iii) The power conductors and equipment are deenergized and grounded.

Table R-2—Approach Distances to Exposed Energized Overhead Power Lines and Parts

Voltage range (phase to phase, RMS) Approach distance (inches)
300 V and less (1)
Over 300V, not over 750V 12
Over 750V not over 2 kV 18
Over 2 kV, not over 15 kV 24
Over 15 kV, not over 37 kV 36
Over 37 kV, not over 87.5 kV 42
Over 87.5 kV, not over 121 kV 48
Over 121 kV, not over 140 kV 54
1 Avoid contact.

Source: eCFR, text current as of 2026-10-15. Read all of 1910.268.

See every company cited for this rule.

Export the list: 18 inspections cited 1910.268(b)(7) in the last 3 years, with employer, location, penalty and date.

Purple Belt, $59/mo

Injuries linked to this rule

4 deaths are linked to inspections where OSHA cited 1910.268(b)(7).

Employee dies from electrocution while installing fiber opti
2024-10-08 · Fatal · NAVARRE, OH

At approximately 3:30 p.m. on October 8, 2024, Employee #1, a 29-year-old male technician, was installing fiber optic cable at a residential location. Employee#1 was working from an aerial bucket truck when he unexpectedly made contact with an energized 7,200-volt overhead power line. The employee…

See all 4 cases

Full case list with employer, penalty, filters and download is part of OSHA Data (Purple Belt).

Unlock with Purple Belt

Where and how often it was cited

YearCitations
20232
20245
20255
20266

Top states: OH (4), TX (4), MI (2), KY (2), NC (1)

Largest penalties

EmployerLocationPenalty for this rule
J B NASSER INCFRONT ROYAL, VA$16,285
CHARTER COMMUNICATIONS INC.EAST BERNE, NY$16,131
MASSILLON CABLE TV, INC.NAVARRE, OH$16,131
MOLDCABLE, INC.LIBERTY HILL, TX$14,895
IMON COMMUNICATIONSIOWA CITY, IA$12,500

Free toolbox talk

A 5-minute crew talk on 1910.268(b)(7), plus alerts when this rule changes. Free.




OSHA interpretation letters

None exist. OSHA has not published a letter of interpretation for 1910.268(b)(7).

Related parts of this rule

Get your crew competent

Trainers on Black Belt Safety: Marc Harvey

Trainers and suppliers: feature your business on this rule for $25/month.

Frequently asked questions

What is the approach distance for 2 kV to 15 kV lines?

24 inches for over 2 kV, not over 15 kV, per Table R-2.

Are insulating gloves enough protection?

Insulating gloves rated for the voltage involved are considered adequate insulation for the employee.

What is the rule for 300 volts and less?

Table R-2 says to avoid contact.

About this page

Sources

3-year window. Federal OSHA only; state-plan rules are not counted. Plain-language text is a summary, not legal advice; the official text controls. Black Belt Safety is not part of OSHA or the Department of Labor.

Written and reviewed by

Black Belt Safety Editorial Team

Site Safety Officer and Safety Professional

OSHA 30 · CPR · USACE CQM

Written and reviewed by the Black Belt Safety team. Every post is checked against the OSHA standard or agency source it cites.

Scroll to top