1926.1153(d)(2): Silica Exposure Assessment
Employers must assess the exposure of each worker who is or may be exposed to respirable crystalline silica at or above the action level, using either the performance option based on air monitoring or objective data, or the scheduled monitoring option. Under scheduled monitoring, results set how often monitoring repeats, and exposures must be reassessed when conditions change.
Key takeaways
- 1926.1153(d)(2) is part of OSHA's construction standards (29 CFR Part 1926, Subpart Z).
- OSHA cited it 645 times in the last 3 years, in 643 inspections, with $389,206 in current penalties.
- 3 deaths are linked to inspections that cited this rule.
- Most citations: MI (115), IL (93), GA (69).
- Related part: 1926.1153(d) Alternative exposure control methods (694 citations).
- Free 5-minute toolbox talk for your crew below.
In this article
What this rule covers
29 CFR 1926.1153(d)(2) ("Exposure assessment") is one requirement inside 1926.1153 Respirable crystalline silica, an OSHA construction standard (Part 1926, Subpart Z). It includes 16 sub-paragraphs. The official text below is copied word for word from the Electronic Code of Federal Regulations (eCFR). The numbers, injury cases and training on this page show how OSHA enforces it on real job sites.
Official text
(2) Exposure assessment — 645 citations
(i) General. The employer shall assess the exposure of each employee who is or may reasonably be expected to be exposed to respirable crystalline silica at or above the action level in accordance with either the performance option in paragraph (d)(2)(ii) or the scheduled monitoring option in paragraph (d)(2)(iii) of this section. Open (d)(2)(i) 623 citations
(ii) Performance option. The employer shall assess the 8-hour TWA exposure for each employee on the basis of any combination of air monitoring data or objective data sufficient to accurately characterize employee exposures to respirable crystalline silica. 8 citations
(iii) Scheduled monitoring option. Open (d)(2)(iii) 10 citations
(A) The employer shall perform initial monitoring to assess the 8-hour TWA exposure for each employee on the basis of one or more personal breathing zone air samples that reflect the exposures of employees on each shift, for each job classification, in each work area. Where several employees perform the same tasks on the same shift and in the same work area, the employer may sample a representative fraction of these employees in order to meet this requirement. In representative sampling, the employer shall sample the employee(s) who are expected to have the highest exposure to respirable crystalline silica. 6 citations
(B) If initial monitoring indicates that employee exposures are below the action level, the employer may discontinue monitoring for those employees whose exposures are represented by such monitoring. Open (d)(2)(iii)(b)
(C) Where the most recent exposure monitoring indicates that employee exposures are at or above the action level but at or below the PEL, the employer shall repeat such monitoring within six months of the most recent monitoring.
(D) Where the most recent exposure monitoring indicates that employee exposures are above the PEL, the employer shall repeat such monitoring within three months of the most recent monitoring. 4 citations
(E) Where the most recent (non-initial) exposure monitoring indicates that employee exposures are below the action level, the employer shall repeat such monitoring within six months of the most recent monitoring until two consecutive measurements, taken seven or more days apart, are below the action level, at which time the employer may discontinue monitoring for those employees whose exposures are represented by such monitoring, except as otherwise provided in paragraph (d)(2)(iv) of this section. Open (d)(2)(iii)(e)
(iv) Reassessment of exposures. The employer shall reassess exposures whenever a change in the production, process, control equipment, personnel, or work practices may reasonably be expected to result in new or additional exposures at or above the action level, or when the employer has any reason to believe that new or additional exposures at or above the action level have occurred. 3 citations
(v) Methods of sample analysis. The employer shall ensure that all samples taken to satisfy the monitoring requirements of paragraph (d)(2) of this section are evaluated by a laboratory that analyzes air samples for respirable crystalline silica in accordance with the procedures in appendix A to this section. Open (d)(2)(v)
(vi) Employee notification of assessment results. Open (d)(2)(vi) 1 citations
(A) Within five working days after completing an exposure assessment in accordance with paragraph (d)(2) of this section, the employer shall individually notify each affected employee in writing of the results of that assessment or post the results in an appropriate location accessible to all affected employees. 1 citations
(B) Whenever an exposure assessment indicates that employee exposure is above the PEL, the employer shall describe in the written notification the corrective action being taken to reduce employee exposure to or below the PEL.
(vii) Observation of monitoring.
(A) Where air monitoring is performed to comply with the requirements of this section, the employer shall provide affected employees or their designated representatives an opportunity to observe any monitoring of employee exposure to respirable crystalline silica.
(B) When observation of monitoring requires entry into an area where the use of protective clothing or equipment is required for any workplace hazard, the employer shall provide the observer with protective clothing and equipment at no cost and shall ensure that the observer uses such clothing and equipment.
Source: eCFR, text current as of 2026-10-15. Read all of 1926.1153.
Injuries linked to this rule
3 deaths are linked to inspections where OSHA cited 1926.1153(d)(2).
At 11:50 a.m. on November 1, 2024, Employee #1 was using a demo-saw to fit two sections of granite curbstone. The saw kicked back, causing the employee to losehis grip on the trigger with his right hand while the saw continued rotating in his left…
Full case list with employer, penalty, filters and download is part of OSHA Data (Purple Belt).
Unlock with Purple BeltWhere and how often it was cited
| Year | Citations |
|---|---|
| 2023 | 49 |
| 2024 | 217 |
| 2025 | 235 |
| 2026 | 144 |
Top states: MI (115), IL (93), GA (69), TX (58), KY (28)
Largest penalties
| Employer | Location | Penalty for this rule |
|---|---|---|
| SUMMIT POLYMERS INC | PORTAGE, MI | $27,500 |
| RESTORATION EAST, LLC | BETHESDA, MD | $26,250 |
| CENTENNIAL CONCRETE & WATERPROOFING LLC | LITTLETON, CO | $19,359 |
| RA MILLER CONSTRUCTION CO INC | HAMILTON, OH | $11,585 |
| EMANUEL ENTERPRISES LLC | FRIENDSWOOD, TX | $11,162 |
Free toolbox talk
A 5-minute crew talk on 1926.1153(d)(2), plus alerts when this rule changes. Free.
OSHA interpretation letters
- Handling and disposal of respirable silica dust, contaminated equipment, and filters from vacuums and PPE (2022-02-14)
- Silica in Construction, Integrated Water Delivery System, Exposure Assessment, Medical Surveillance, Respiratory Protection (2019-03-04)
- Interim Enforcement Guidance for the Respirable Crystalline Silica in General Industry/Maritime standard, 29 CFR 1910.1053 – June 23, 2018, Enforcement Date (2018-06-25)
- Interim Enforcement Guidance for the Respirable Crystalline Silica in Construction Standard, 29 CFR 1926.1153 (2017-10-19)
Related parts of this rule
- 1926.1153(d) Alternative exposure control methods 694 citations
- 1926.1153(d)(2)(i) General 623 citations
- 1926.1153(d)(1) Permissible exposure limit (PEL) 35 citations
- 1926.1153(d)(3) Methods of compliance 14 citations
- 1926.1153(d)(3)(i) Engineering and work practice controls 14 citations
- 1926.1153(d)(2)(iii) Scheduled monitoring option 10 citations
- 1926.1153(d)(2)(vi) Employee notification of assessment results 1 citations
- 1926.1153(d)(2)(iii)(E)
- 1926.1153(d)(2)(iii)(B)
- 1926.1153(d)(2)(v) Methods of sample analysis
Get your crew competent
Trainers on Black Belt Safety: Marc Harvey, Dana Reyes
Trainers and suppliers: feature your business on this rule for $25/month.
Frequently asked questions
What are the two ways to assess silica exposure?
The performance option, using air monitoring or objective data, and the scheduled monitoring option, using personal breathing zone air samples.
How often is monitoring repeated if results are at or above the action level but at or below the limit?
Within six months of the most recent monitoring.
When can scheduled monitoring stop?
When initial monitoring is below the action level, or when two consecutive measurements taken seven or more days apart are below the action level.
About this page
Sources
- 29 CFR 1926.1153 (eCFR), text current as of 2026-10-15
- U.S. Department of Labor enforcement data: OSHA inspections, citations and accident records, copied nightly; data as of 2026-10-20
3-year window. Federal OSHA only; state-plan rules are not counted. Plain-language text is a summary, not legal advice; the official text controls. Black Belt Safety is not part of OSHA or the Department of Labor.
